Roberts Gorden MGB Series Instrukcja Obsługi Pobierz pdf (Strona 12)

COMBAT

CABINET HEATERS INSTALLATION, COMMISSIONING, OPERATION AND SERVICE MANUAL

6 of 85

Figure 2: Installation Clearances and Clearances to Combustibles

3.4 Ventilation

It is important to ensure that there is adequate air

circulation around the heater to supply air for

combustion, ventilation and distribution in

accordance with local and national codes.

3.5 Fuel Supply

It is important that the fuel supply pipe is sized

correctly to provide the inlet pressure as stated on

the heater data plate. The gas/oil supply pipe and

electrical connections must not support any of the

heater's weight.

.6 m (2')

.6 m

(2')

*.6 m

(2')

*.6 m

(2')

*.6 m (2')

4 m (13.2')

The flue pipe must have clearance from combustibles by 5 cm.

If installed where individuals can come in contact with the pressure relief door or other hot components,

adequate guarding must be provided.

All distances are minimum clearance requirements for service access, air flow and safety.

*A service clearance of 1 m is required on one side to allow for fan replacement.

WARNING

Carbon Monoxide Hazard

Heaters may be installed vented or unvented.

Vented heaters must be vented outdoors.

Unvented heaters must be installed in buildings

with ventilation rates as per section 7.

Failure to follow these instructions can result in

death or injury.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 91 92

Brak uwag

Roberts Gorden MGB Series Instrukcja Obsługi Strona 12